“The Tram” E-Leveler Electronic Bed Leveling Tool

How the Tram Works

---

You run the tram GCode files just like any 3D Print.

The GCode file will position the nozzle over each adjuster with the perfect 5.8 mm Z-offset for the E-Leveler.

It will automatically move to the corner (left front first) so you can level that corner with the E-Leveler so the LED just turns on. The GCode will automatically move to the next position after 20 seconds so you can level the next corner. It continues until all corners are leveled.

(Full Instructions are below).

G-Code Files To Use Your E-Leveler Right Click on "Download File" below and Select "Save Link As" to save to your computer.

Unzip the file and you will find a Folder with three separate sub-folders:
Ender 2 size (180x180 bed), Ender 3 Size (220x220 bed) and Ender 3 Max Size (300x300 Bed).

Choose the folder that matches closest to your printer's size (it doesn't have to be an Ender just similar in size) and copy the two GCode files, within the folder for your size printer, to your SD card. Insert the SD card into your printer and follow the instructions below.

---

Download File
To Download: ​Right Click on Download File and Select "Save Link As"

---

Instructions

---

1. Run the Ender_x_Size_E-Leveler.gcode file just like any 3D print and it will position to the front left corner.
2. Position the E-Leveler under the nozzle (it doesn't need to be heated).
3. Adjust the bed knob until the LED just begins to turn on.
4. The G-Code will automatically move to the next position (left rear) in 20 seconds.
5. Adjust the bed knob until the LED just begins to turn on.
6. Complete all 4 corners and then the G-Code file will return the nozzle to home position.
7. Next Run the Squares (Ender_x_Squares_Test.gcode) G-Code file to verify the bed is level.
8. Repeat Step 1 if the Squares test doesn't look even.