Having the power switch in the back of your buddy board case is simply a pain, move it to where you want it! (even outside of an enclosure.)
Trying to wind your hand through the X-axis wiring, without knocking over your roll of filament is tough (Imagine one of those late night infomercials, where a guy tries his best to fry an egg in his beat up old pan, butter and egg and sweat flying everywhere.) Let Squishworx make it easier for you.
Slap the included high quality T Spring Ball Nuts into the left hand extrusion, pop open your buddy board case, pull a couple of wires, push on our fully wired power switch cable with perfectly matched spade connectors (We use high quality, braided 16awg cable with a silicon insulator). And your problems are a thing of the past. Your power switch is immediately at hand, interfered with by nothing. Enjoy it!
Quick 5 minute install. All hardware necessary is included (Roller T-Nuts so you don’t have to disassemble your finely tuned Mini to install!) bolts, 24 inches of power cable to allow you to place that switch, anywhere, Crimped female disconnects and fully printed housing in Prusament Black or Prusament Orange) and we toss in an exact Prusa power switch.